Friday, December 9, 2016
Error Code for Canon Pixma Mp258
Error Code for Canon Pixma Mp258
P02 (Carriage error)
- Make sure no foreign material stuck to the print head railway.
- Clean and check the print head encoder strip cable (timing slit film or encoder strip is a white line on the back of the box set of ink lines may be missing or mess up the ink.
P03 (Line feed error): an error in transmission line entering the line feed (LF) is a signal telling the printer to move to another line or a whole new line that would not otherwise have reached the end of the line.
- Check wire print head position (timing slit disk film) on the side of the machine.
- Check PCB logic board.
P05 (ASF sensor error) sensor for paper feed error.
- Try to replace the following:
- ASF / PE sensor unit.
- Drive unit.
- PCB logic board.
P06 (Internal temperature error): caused by abnormal heat inside the printer.
P07 (Ink absorber full): the Ink Wastepad (sponge) inside the printer is full
- Replace the wastepad inside the printer or install waste ink bin outside the printer
- then Reset counter protection.
P08 (Print head temperature rise error): caused by thermal print head temperature exceeds a threshold.
- Replace the new cartridge print head and / or change a new logic board.
P09 (EEPROM error): caused by corrupted or defective EEPROM chips of the printer.
- Replace the logic board.
P15 (USB VBUS over current): caused by too much current, try removing the USB cable and then plugin again, if solve the error, try to replace with a new USB cable. If the error still exist replace the logic board.
P20 (Other hardware error): The failure of other hardware.
- Try to replace the logic board.
P22 (Scanner error): a scanner malfunction.
- try to change the scanner unit or change a the logic board.
E13 or E16: Ink has run out
- Pressing the Stop / Reset button for 5 to 8 seconds until the led screen display number 1.
E04, E05, E14 or E15: Cartridge may not be installed properly
- Reinstall the ink cartridge.
Available link for download
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment